Anima USD/CNTile Upscale workflow (Anima 放大工作流)

Upscaling with Ultimate/ Tile Controlnet SD Upscale & Anima Models

基于 Ultimate SD Upscale 或 Tile Controlnet 与 Anima 模型的放大工作流

Thanks @L_A_X for the tile Controlnet

CNTile Upscale Parameter Notes
- Prompt: Use the original image's prompt.
- Denoising Strength: Recommended range is 0.25 – 0.75.
- Steps: Adjust according to denoising strength, typically 6 – 20+ steps.
- Upscaled resolution: 1536–2560.
- Sampler: er_sde is recommended.
- Controlnet strength: 0.4–1.0; recommended strength 0.7 and cn ended at0.8.

- Plz download CN model from here: https://civitai.com/models/2708551
USD Upscale Parameter Notes
- Prompt: original image's prompt
- Denoising Strength: Recommended range is 0.15 – 0.35.
- Steps: Adjust according to denoising strength, typically 6 – 15 steps.
- Tile Size: AP3 1280, Anima Base 1536.
- Sampler: er_sde recomanded

CNTile 放大参数说明
- 提示词：使用原图的提示词。
- 重绘幅度（Denoising Strength）：建议范围 0.25～0.75。
- 步数（Steps）：根据重绘幅度调整，通常为 6～20+ 步。
- 放大后分辨率：1536～2560。
- 采样器（Sampler）：推荐使用 er_sde。
- ControlNet 强度（CN strength）：范围 0.4～1.0，推荐 0.7且在0.8结束(CN tile模型在这里下载:https://civitai.com/models/2708551

USD Upscale 参数说明
- 提示词：原图生成时的提示词
- 重绘幅度（Denoise）：建议设置在 0.15～0.35 之间。
- 步数（Steps）：根据重绘幅度调整，推荐 6～15 步。
- 切片基础尺寸（Tile Size）：AP3 1280, Anima Base 1536.
- 采样器（Sampler）：推荐使用er_sde

Update Log
- 26/04/12: Version 1.1 updated to preview3.
- 26/04/18: Version 1.1 added a Lora loader and adjusted parameters;
- 26/05/14: Version 1.2 introduced the following QoL (Quality of Life) nodes:
- Auto tile sizing
- Comparison preview
- Save with metadata
- 26/06/21: Version 1.2a adjusted baseline parameters for improved default performance.

- 26/06/21: add first controlnet tile upscale experimental workflow